Carpet Cleaning Injection Sprayer 8-1 Dilution HydroForce Blow Mold 1639-0775

Description

StainOut Injection Sprayer Plus High Pressure with blow molded jug
Description
The original injection sprayer (100 - 1,000 PSI).  Finish Jobs Faster with Injection Sprayers. For those that want an exceptional sprayer at a great price.
Features
Most affordable sprayer on the market
Operating pressure range of 100-1,000 PSI
Eliminates annoying mixing required by pump up sprayers
Specifications
Blow molded, 5 qt. transparent container
7 dilution ratios using metering tip kit NA0816A
Spray gun rated at 2600 PSI and 7 GPM
Chemically-resistant seals
18" stainless steel wand
Video
src="https://www.youtube.com/embed/Nap5K5Oa7dI?rel=0" allow="accelerometer; encrypted-media; gyroscope; picture-in-picture" allowfullscreen="" width="853" height="480" frameborder="0">
Compare to current or past OEM associations:
Multi-Sprayer INJ-6
8.697-413.0
86974130
PR101
AS08P
1639-0775
T-015
Additional Information
General Function:
The Injection Sprayer is based upon an injection system that consists of a specially designed valve that injects a concentrated chemical into the high-pressure water flow from the machine. Injection sprayer is designed for use with incoming water pressure of 400 PSI. The water flow is automatically reduced as it passes through the injector valve, thus reducing the pressure approximately 64%. To obtain the actual working pressure of your Injection Sprayer, multiply your incoming pressure by 36%. The Injection Sprayer is factory set to inject chemicals at a 1 to 8 ratio. Other chemicals may be used but should be prepared for a 1 to 8 dilution. The pressure can be increased by putting a smaller jet at the end of the wand. This will, however, decrease the injection rate of your chemical. Your injection ratio may also change depending on the viscosity (thickness) of your chemical concentrate. The 1 to 8 ratio is based upon chemicals with a similar viscosity to water. The injection ratio can also be slightly affected by your main flow water temperature. This is generally not enough of a change to appreciably change the effectiveness of your system. We do, however, recommend the water temperature be kept below 200 degrees Fahrenheit, as higher temperatures can cause problems on the injection.
Pre-Spray and Traffic Lane Applications:
Injection Sprayer eliminates the hassles of measuring and mixing. We recommend you keep an extra 5-quart container or two on your truck to make sure you never run out and to facilitate quick changes of your chemical containers. Remember that Injection Sprayers automatically mixes at a 1 to 8 ratio. If your 5-quart container is full then that is the same as holding an 11-gallon pump sprayer of regular, ready to use pre-spray. We have found that Injection Sprayers offer better penetration and overall coverage than most other sprayers. It is therefore possible to pre-spray your jobs up to 45 minutes before you reach that area to be cleaned. An effective way to use the injection sprayer for pre-conditioning or small to medium jobs is to start at the door coming into the house, spraying all the traffic areas, working your way to the farthest point back in your job. You have then completed your pre-conditioning in just seconds and are prepared to hook up your wand and start cleaning your way out. Keep in that your spraying 3 to 4 times the amount of product your normal pump sprayer is putting out. This means you must move quickly to avoid over-applying. Protector should be applied in even, slightly overlapping strokes.